Roland TrueVIS VG3-640 User Manual page 281

Replacing the Blade/Separating Knife
Check item
Check the shape of the
square you have peel-
ed off.
9.
Tap or
Cutting condition
[Blade Force]
[Cutting Speed]
[Blade Offset]
[Rise Movement Speed]
10.
Press [Save] to confirm your entry.
11.
Repeatedly perform the cutting test and adjust the cutting conditions until the settings are optimized.
Repeat steps 8 to 11 to adjust the cutting conditions.
12.
Tap to go back to the original screen.
280
Replacing Consumable Parts
Result
The corners are not rounded
and do not have "horns."
The corners are rounded.
The corners have "horns."
to change the settings.
Set the force (pressure) of the blade.
Set the speed of cutting.
Set the blade offset. Enter the listed offset value for the blade.
The offset value for the included blade is 0.250 mm (9.8 mil).
Set the blade's up speed during cutting (the speed at which the
blade travels when it moves to the next cutting line after cut-
ting one cutting line). If the media comes loose during no-load
feed and the blade damages the surface of the media, reduce
the speed.
Setting item
[Blade Offset]
Setting details
Adjustment
No change
Increase
Reduce
Default set-
tings
50 gf
30 cm/s
0.250 mm
(0.010 in.)
30 cm/s