Repeat Playback - Automatic Cyclical Playback; Setting Points A And B For Repeat Playback - Sony HDV HVR-1500 Operating Instructions Manual

YES: output possible / NO: output not possible
Playback Image
speed quality
×24 Coarse
×8 Coarse
×1 Normal
×1/5 Normal
×1/10 Normal
×1/30 Normal
Forward Normal
frame-by-
frame
STILL Normal
×–1 Coarse
×–8 Coarse
×–24 Coarse
Note
Audio cannot be played back at variable speed for HDV
format.
Supported playback speeds for DV/DVCAM/
DVCPRO format
The possible playback operations for DV/DVCAM/
DVCPRO format, and supported playback speeds are as
follows.
Playback operation Playback speed
Shuttle playback –60 to + 60 times normal speed
(search audio can be checked in
range of –10 to +10 times normal
speed.)
Frame-by-frame Low speed search, frame units
playback
Digital slow-motion –1/2 to +1/2 times normal speed
(audio slow-motion playback
possible using noiseless/digital
jog sound. )
Jog audio
–1/2 to –1/30, +1/30 to +1/2
times normal speed
Still Still image of desired field
For details of how to carry out a search operation on an
external device, refer to the operating instructions for the
particular device.
Repeat Playback — Automatic
Cyclical Playback
Proceed as follows to perform automatic cyclical playback
of recording (repeat playback) between selected start and
end points.
Video output i.LINK
output
YES YES
YES YES
YES YES
YES NO
YES NO
YES NO
YES NO
YES NO
YES YES
YES YES
YES YES
1
Set the desired repeat start and end points with the
REPEAT FUNCTION menu item (see page 73).
You can set points A and B as start and end points by
following the procedure described in the next section.
2
Set the REPEAT MODE menu item (see page 73) to
ON.
The repeat indicator lights.
3
Press the SET (YES) button to save the new setting
and close the menu.
4
Press the PLAY button.
The unit starts repeat playback from the repeat start
point set in step 1.
Setting Points A and B for Repeat
Playback
You can set the repeat playback start point (point A) and
end point (point B) by using the current tape position or
inputting timecode values.
To perform repeat playback after setting points A and B,
press the PLAY button. When the DSRM-10 Remote
Control Unit is connected, you can also start repeat
playback by pressing its PLAY button.
Note
When performing repeat playback using points A and B as
the playback start and end points, make sure that the
REPEAT TOP and REPEAT END menu items (see
page 73) are set to A POINT and B POINT, respectively.
47
Playback