HOLLICY SX1888 Assembly/Disassembly Manual page 16

Table of Contents

Advertisement

(1).Put the car on flat ground, don't adjust the steering wheel, make the
steering wheel in middle position, turn on the power.
(2).When the car has been turned on, adjust the steering wheel to make
the wheels in right front position, then make steering wheel to keep still.
(3).Press the "speed selection" switch on remote control for 5 seconds
until speed indicator light start to flash, then release the switch, now
adjusting has finished.
(4).If failed, please repeat the steps 1-3.
1 . When operating the car, the distance between the car which kid
sit in and the adults operating the remote should not be more than 10
meters.
2 .The remote is only for adults to use.
3 .Before using the remote, must read the instruction manual
carefully, and check , only when knowing the way of operation, you
can use the remote with kid in the car.
4.This remote control car should not be in road and water, obstacles,
etc.
5 .Avoid getting the remote control wet in rains.
6 .Don't mix using the old and new batteries and different brands of
batteries.
7 .If not use the remote control for a long time, it is suggested that to
take out the battery, in order to avoid battery leakage, corrosion
circuit board,so that damage the remote control.
8. Should be avoided fall in the process of remote control.
9. If the remote distance is less than 3 meters, it means the battery is
down in the remote control, it is time to change the 2 pieces of AA
alkaline batteries.
10.Avoid to drop the remote control during using.
11. Install batterise with right polarity, avoid battery short circuit.
12. Charging must be done by adults, Non rechargeable batteries
can't be charged.
13. Run out of battery should be removed from the toy properly and
prevent children from playing.
14. Take out the battery if no use for long time, properly handle the
battery, prevent children from playing.
How to insert batteries: Use screwdriver to
loosen the screw on the back of the
remote control, open the battery cover, and
install two AA 1.5V alkaline type batteries
according to the diagram (Batteries
provide for yourselves), then close the
battery cover,and fix with screw.
WARNING:
14
AA 1.5V
AA 1.5V

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents