Advertisement
Chapter 5 Safety and Regulatory Information
Electrical Safety Information
The voltage, frequency and current requirements indicated by the manufacturer's label must be
met. If these restrictions are not adhered to, connecting to a non-specified power supply can result
in abnormal operation, equipment damage, or fire.
There are no serviceable parts for the operator inside the equipment. The hazardous voltage
generated by the equipment is a safety hazard. Repairs can only be carried out by qualified service
technicians.
If you have questions about the installation, contact a qualified electrician or manufacturer before
powering the device on.
Emissions and Immunity Information
U.S. Users Note: This device has been tested and meets the limits of Class A digital devices under
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in residential installations. This equipment generates, uses and radiates radio
frequency energy, which, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications.
Canadian Users Note: This equipment complies with the Class A radio noise emission limits for
digital equipment set out in the Canadian Industrial Radio Interference Regulations.
NOTES: Use only the power cords and interconnect cables supplied with the device.
Replacement of wires and cables provided may endanger electrical safety or CE mark certified
emissions or exemptions as required by the following standards:
This Information Technology Equipment (ITE) requires a CE mark on the manufacturer's label,
which means that the device has been tested for the following instructions and standards: This
device has met the European standard EN 55032 Class A EMC Directive 2014/30/EU and
European standard EN 60950-1 Low Voltage Directive 2014/35/EU CE marking requirements.
General information for all users: The device generates, uses, and radiates radio frequency energy.
If not installed and used in accordance with this manual, the equipment may interfere with radio
and television communications. However, there is no guarantee that interference will not occur due
to site-specific factors in any particular installation.
1. In order to meet emission and immunization requirements, users must comply with the following
regulations:
a. Connect the digital device to any computer using only
b. To ensure compliance, use only the manufacturer-approved power cord provided.
User manual: KIT-NFC-LF/HF-EDGE CONNECT
the
provided I/O cable.
Page 16 of 20
Advertisement
