Table of Contents
Advertisement
QB-RL78D1A2 In-Circuit Emulator
(c) Ensuring isolation
Adjust the height of the QB-RL78D1A2 with the front space adapter and the rear space adapter and ensure
isolation from the target system.
(d) Precautions related to emulation probe
<1> Be careful that stress of the emulation probe is not placed on the target connector. Moreover, when
removing the emulation probe, remove it slowly while pressing down on the exchange adapter with a
finger so that there is no stress on the target connector.
<2> Be sure to connect the GND wire of the emulation probe to the QB-RL78D1A2 and the target system.
If it cannot be connected, the impedance of the cable is unstable and could bring about lowering of
signal transmission characteristics or distortion of the output waveform for an input waveform.
R20UT3110EJ0101 Rev.1.01
Nov 28, 2014
Figure 2-7 Where GND Wire Can Be Connected
L = 60 mm
(J)
24.7 mm
CHAPTER 2 SETUP PROCEDURE
34.3 mm
(K)
L = 60 mm
User system
Page 28 of 41
Advertisement
Table of Contents
