Renesas QB-RL78D1A2 User Manual page 10

QB-RL78D1A2 In-Circuit Emulator
(1) TCN1, TCN2, TCN3
These are connectors for connecting a check pin adapter or emulation probe.
(2) OSC1
This is a socket for mounting the oscillator.
(3) CN6, TCN4
These are connectors for the shipment inspection. User does not need to use these connectors.
(4) POWER (Red LED)
This is an LED that shows whether the power supply of the QB-RL78D1A2 is switched on.
LED State
Lit
Not lit
Blinking
(5) TARGET (Green LED)
This is an LED that shows whether the power supply of the target system is switched on.
LED State
Lit
Not lit
(6) Power switch
This is the power switch of the QB-RL78D1A2.
It is OFF at shipment.
(7) Cooling fun
This is the cooling fun of the QB-RL78D1A2.
It works when the power supply of the QB-RL78D1A2 is switched on.
R20UT3110EJ0101 Rev.1.01
Nov 28, 2014
Power switch ON
Power switch OFF or AC adapter not connected to QB-RL78D1A2
Internal error occurred (Contact an Renesas Electronics sales representative or
distributor)
Target system power supply ON
Target system power supply OFF or target system not connected
QB-RL78D1A2 State
Target System State
CHAPTER 1 GENERAL
Page 10 of 41