Chart Recorders; Set Up And Operation - Thermo Scientific 325099H11 Installation And Operations

Chart Recorders

10 Chart Recorders
10.1 Set Up and
Operation
16 Laboratory and Plasma Freezers
Panel-mounted six inch recorders are standard and factory-installed on all
models except for undercounter models, for which free-standing recorders
are provided.
Recorder operation begins when the system is powered on.
To prepare the recorder to function properly, complete the following steps:
1. Open the recorder door to access the recorder.
2. Connect the nine volt DC battery located at the recorder's upper right
corner. This battery provides back-up power.
3. Install clean chart paper (refer to Section 10.2 below).
4. Close the recorder door.
Note : The recorder may not respond until the system reaches temperatures
within the recorder's range.
Chart Buttons
Imprinting
Stylus
Reference Mark
Hub-Nut and
Retaining Wire
Figure 2. Six Inch Chart Recorder
9 Volt Battery
Chart
Thermo Fisher Scientific