Table of Contents
Advertisement
Drawers
11.2 Reinstalling the
11.3 Changing Drawer
20 Laboratory and Plasma Freezers
To reinstall the drawers in 23 cu.ft. models and larger, complete the
Drawers
following steps (refer to Figure 4):
1. Pull both drawer slides toward you until the slides are fully extended.
2. Position the drawer between the slides and with the back facing end
raised at a 45 degree angle, insert the front mounting clips into the slots
on front of the slides.
3. Push the back of the drawer down between the slides and insert the
drawer tabs into the back slots.
Note : The drawers fit snugly between the slides. Push on the back of the
drawer from the inside to insert the drawer tabs completely into the slots.
Make sure both drawer tabs are aligned with the slots on the slides before
pushing the drawer down between the slides.
The drawer slides are adjustable to higher and lower positions in the cabinet.
Position
You can position these slides in the vertical slots which are spaced at
one-inch intervals.
Drawer slides have a small wire safety clip at the front pilaster which
prevents the slides from falling when the drawers are removed. To change
the position of the drawer slides, complete the following steps:
1. Locate the safety clip.
2. Slip a small screwdriver under the bottom of the wire clip and pry the
clip out toward the inside of the freezer.
3. Lift up the slide at the front. The slide is free to move from the front
pilaster.
4. The drawer slide must be removed from the rear pilaster at
approximately a 45 degree angle toward the center of the cabinet.
5. Pull the slide toward the front of the cabinet.
6. Reposition the slide to the desired vertical slot.
7. Replace the safety clip.
CAUTION : Drawer slides do not require lubrication. Additional lubricant
could impede movement of the drawers when the lubricant is cold.
Thermo Fisher Scientific
Advertisement
Table of Contents
