Advertisement
16. Filling the water tank
Fill fresh water (without additives) into the tank up to the marking.
17. Speed regulation
The suction power can be adjusted via the speed regulation. Turn the
controller clockwise to increase the suction power and counter-clock-
wise to reduce the suction power.
18. Automatic dust suction
Connect the electric device with the suction hose and the mains plug of
the multi-functional cleaner.
22. Emptying the filter bag
Open the clear cover on the top of the cleaner.
23. Emptying the filter bag
Open the filter bag on the bottom by removing the cover and empty the
bag. Close it and place it back again.
24. Emptying the water container
Remove the upper part of the cleaner and remove the dirty water. Clean
the water container with clean water.
Notes:
•
When using this vacuum cleaner to remove sanding dusts, check that the type of dust is suitable
for the vacuum cleaner.
•
Switch the on/off switch to the "=" position after installing the connections. When turning the
connected electric device on, the vacuum cleaner will turn on with a short delay of approximately
1 s. After using the electric device and switching it off, the vacuum cleaner will switch of after
approx. 10 s.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62641
Page 8
01
2022-1
Advertisement
