Troubleshooting; Specifications - Teac RC-L800 Owner's Manual

Troubleshooting

If you experience any of the following difficulties
while using the unit, use this troubleshooting guide
to help you remedy the problem. Should any
problem persist, consult your nearest service
center.
The unit does not function
e Remove any obstacles between the unit and
the system.
e Use the unit closer to the system.
e Point the unit at the front panel.
e Replace all the batteries in the unit with new
ones if they are weak.
e Check to see that the batteries are installed
correctly.
The unit does not respond to key presses
e Remove the battery cover and remove one
battery. Reinsert the battery and replace the
battery cover and operate the unit normally.

Specifications

Dimensions (W x H x D): ................60 x 208 x 24 mm
Weight:.......................................150 g (w/o batteries)
Number of emulating devices:.....................Up to 16
LCD screen size: ........................................39 x 90 mm
Back-lighting Device:...........................................LED
Accepted Signal Frequency for Learning:
............................10–125 kHz, 455 kHz and Pulse
Memory:..............256 KB non-volatile flash memory
Batteries: ...........................................AAA Battery x 4
Power Consumption:
LCD Off ........................................................ 50 µ A
LCD On ...................................................... 350 µ A
Operated ............................................ 30–150 mA
Batteries Life: ....Approx. 2–3 month (Mn batteries)
..............Approx. 4–5 month (Alkaline batteries)
Operating Distance: ..............................Approx. 10 m
Interface: ............................................................UART
Standard Accessories:
Battery (AAA, R03, UM-4).................................. 4
Mini-plug cable................................................... 1
USB cable ............................................................ 1
Owner's Manual ................................................. 1
RemoteComm Getting Started.......................... 1
Pre-programmed Code List............................... 1
35