Instructions - TMC Reef Pump Compact 500 Instructions Manual

Caution: Do not use any power supply other than the one supplied with your genuine Reef Pump Compact. The use of a different power
supply will invalidate the guarantee.
Caution: The Reef Pump Compact controller is not waterproof and therefore must not be mounted above the aquarium or sump, or in
any position where it may accidentally fall into water or be splashed by water.
• Always isolate the PSU from the mains electricity before installing or carrying out any maintenance to the pump.
• Only use the correctly-rated controller supplied with the pump. A label on the back of the controller denotes which pump it is designed for.
Using the wrong controller with the wrong pump will invalidate the guarantee.
• Power to the pump must be supplied through a Residual Current Device (RCD) with a rated residual operating current not exceeding 30mA.
• Never operate the pump without water inside the impeller chamber or with liquids at a temperature higher than 95F/35°C.
• To ensure the pump continues to maintain a steady water flow, it must be cleaned regularly to ensure it does not become clogged with debris
or detritus.
• Do not operate any appliance if it has a damaged cord or plug, if it is malfunctioning, or if it has been dropped or damaged in any way.
• This unit is designed to be used indoors and is not suitable for any outdoor applications.
• Always leave a drip-loop in the pump cable to prevent water running down the cable and reaching the controller and power source (see
diagram).
• The controller will heat up under normal circumstances, but should never get too hot to handle.
• Dispose of this unit responsibly. Check with your local authority for disposal information.
5
INSTRUCTIONS FOR INSTALLATION AND USE
Important Safety Information - Please Read Carefully
5