TAS APFC-06 04 User Manual page 22

Power Factor Controller APFC 06
...continued.
For Testing banks with manual ON / OFF commands:
Press ENTER key, the cursor will start blinking. Use ◄► keys
to select the specific bank/s that are healthy and use ▲ key to
turn ON and use ▼ key to turn OFF that capacitor banks.
To come out of Manual ON/OFF edit mode, press ↵ key so that
cursor stops blinking.
Edit Parameters:
This mode is used to carry out system settings. In this mode
various system settings can be carried out. To do the same,
use the ▲▼ keys and select the type of parameters to be
edited. The types of parameters that can be edited are:
General & IO
System
Fault
Step
Utilization counter: Bank operations utilization counters. Utilization counter: Bank operations utilization counters.
After selecting the type, press ↵ to enter the sub-menu of that
specific type.
The details of these sub-menus for every type is given further.
You can edit all these sub-menu settings by using the ↵, ▲, ▼,
◄ and ► keys.
To come out of the sub-menu press Triple▼ key once.
To store the edited parameters permanently, press ■(memory)
when you are either in the Edit Parameters or any sub-menu
area.
To come out of Edit Parameters without saving the changes
press Triple▼ key again.
Note: In the Edit Parameters mode, if no keys are pressed for
more than 5 Minutes, the default display screen comes on and the
changes done in edit parameters mode till that time are
discarded.
: For general settings.
: For APFC system settings.
: Fault settings.
: Capacitor bank step settings.
- 20 -