Location; Installation; Electrical Connections - Hoshizaki KM-40C Instruction Manual

Self-contained crescent cuber
Hide thumbs Also See for KM-40C:
Table of Contents

Advertisement

Available languages

Available languages

ENGLISH
2) Remove the shipping tape holding the door and separator.
3) Remove the protective plastic film from the exterior. If the icemaker is exposed to the sun or to heat, remove the film after the
icemaker cools.
4) Remove the package of accessories. Check the contents according to "2. ACCESSORIES".

4. LOCATION

This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
The location should provide a firm and level foundation for the icemaker.
Do not place anything on top of the icemaker or in front of the louver.
Normal operating ambient temperature should be within 1°C to 40°C. Normal operating water temperature should be within
5°C to 35°C. Operation of the icemaker, for extended periods, outside of these normal temperature ranges may affect
production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Top View
Left
15 cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.

5. INSTALLATION

Incorrect installation can cause harm to people, animals or other items, for which the manufacturer cannot be held
responsible.
* Place the icemaker in the selected permanent site.
* The appliance must be positioned so that the plug is accessible.
* Level the icemaker in both the left-to-right and front-to-rear directions by adjusting the legs or adjust bolts.

6. ELECTRICAL CONNECTIONS

This icemaker requires an earth that meets the national and local electrical code requirements.
To prevent possible severe electrical shock to individuals or extensive damage to the unit, install a proper earth wire to the icemaker.
Disconnect the main power supply before any maintenance, repairs or cleaning is undertaken.
IMPORTANT
Rear
15 cm
Right
15 cm
ICEMAKER
Front
THIS APPLIANCE MUST BE EARTHED
WARNING
CAUTION
NOTICE
Side View
Front
40 cm
CAUTION
WARNING
4
Top
15 mm
Rear
15 cm
ICEMAKER

Advertisement

Table of Contents
loading

This manual is also suitable for:

Km-60cKm-80cKm-40c-wKm-60c-wKm-80c-w

Table of Contents