Communications; Modbus Client; Sylk™ Supported Devices; Differential Pressure Sensor - Honeywell Spyder 7 Installation Instructions Manual

SPYDER MODEL 7 VAV CONTROLLER INSTALLATION INSTRUCTIONS

Communications

Table 7 Communication Specification
Parameter
Protocol supported
Ethernet
Connection Speed
Internet Protocol
Version
IP Addressing
Modes
Sylk™ bus
Bluetooth

Modbus Client

Table 8 Modbus Client Specifications
Parameter
2-wire serial line (TIA/EIA-485)
Physical Layer
(with additional common).
Communication 9.6, 19.2, 38.4, 57.6, and 76.8 kb/s
rates supported.
Maximum
32, It is recommended to connect a
numbers of smaller number of devices for
devices better Modbus performance.
Cable and wiring See
specifications Specifications on page
Communication
Modbus client only.
Mode
Transmission
RTU (Remote Terminal Unit).
Mode
Modbus clients can have an
address between 1 and 247.
Discrete inputs, coils, input
Address Range
registers, and holding registers can
have an address between 1 and
65534.
31-00475-01
Specification
BACnet IP, BACnet MSTP,
Sylk™, Modbus RTU (Modbus
client only), and BLE.
10/100 Mbps
IPv4
• Dynamic: DHCP and Link
Local
• Static
2-wire, polarity-insensitive
BLE for using mobile
balancing application.
Specification
TIA/EIA 485 Cable
21.
Sylk™ Supported Devices
Table 9 Sylk™ Supported Devices
Parameter
TR40, TR40-H, TR40-CO2, TR40-H-
Sylk™ wall CO2, TR42, TR42-H, TR42-CO2,
modules TR42-H-CO2, TR71, TR71-H, TR75,
TR75-H, TR120, and TR120-H.
Sylk™ sensor C7400S Sylk™ sensor
MS3103, MS3105, MS4103,
MS4105, MS7403, MS7405,
MS7503, MS7505, MS8103,
MS8105 spring return direct coupled
actuators (DCA) are used within
Sylk™
Heating, Ventilating, and Air-
actuator
Conditioning (HVAC) systems.
They can drive a variety of quarter-
turn; final control elements requiring
spring return fail-safe operation.

Differential Pressure Sensor

Table 10 Differential Pressure Sensor Specification
Parameter
±2.0 H
Range
±3 % of full range
Accuracy
Field replaceable differential pressure sensor.

Weight And Dimensions

Table 11 Weight And Dimensions
Parameter
Dimension 7 x 6 x 3 1/2 in. (175.2 x 154.3 x 90.2
(L x W x H)
mm)
3.06 lb (1.5 Kg)
Weight
Fixation with bracket and shaft
Mounting
6
Specification
Specification
O (±500 Pa), bi-directional
2
Specification