Adjusting The Throttle Cable - Stihl FS 160 Instruction Manual

English
5.3.3 Mounting the control handle
3
1
2
► Take out the screw (1) – the nut (2) remains in
the control handle (3).
► Push the control handle onto the handlebar (5)
until the holes (6) line up – the throttle trig‐
ger (4) must point towards the gearbox.
► Insert screw and tighten it down firmly.
70
4
6
5
6

6 Adjusting the Throttle Cable

5.3.4 Fitting the throttle cable retainers
NOTICE
Do not kink the throttle cable or lay it in tight radii
– make sure the throttle trigger moves freely.
7
10
9
► Press one throttle cable retainer (7) into the
upper hole (8) and one into either of the lower
holes (9).
► Press the third retainer (7) into the hole (10) in
the clutch housing cap.
5.3.5 Adjusting the throttle cable
► Check adjustment of throttle cable – see chap‐
ter on "Adjusting the Throttle Cable".
6 Adjusting the Throttle
Cable
Some machine versions are equipped with a
throttle cable adjuster on the control handle.
A properly adjusted throttle cable is the precondi‐
tion for correct operation in the full throttle, start‐
ing throttle and idle positions.
Adjust the throttle cable only after the unit is fully
assembled – the control handle must be in the
normal operating position.
8
7
7
0458-323-8721-D