Adjusting The Throttle Cable - Stihl FR 350 Instruction Manual

A
4
10
Securing the Loop Handle
: Secure the loop handle (4) about
20 cm (A) forward of the control
handle (9).
: Line up the loop handle.
: Tighten down the screws firmly and
lock the nuts if necessary.
Sleeve (10) is supplied in some
markets and must be between the
loop handle and control handle.
FR 350, FR 450, FR 480
2
9
1
Fitting the Throttle Cable
: Push the throttle cable (1) into the
two cable retainers (2) about 20 cm
(A) from either end of the shaft.
The throttle cable must be
positioned parallel to the flexible
shaft over its whole length. Do not
wrap the throttle cable around the
flexible shaft.
Throttle Cable Adjustment
Go to "Adjusting the Throttle Cable".

Adjusting the Throttle Cable

A
1
A
2
:
A properly adjusted throttle cable is
the precondition for correct
operation in the full throttle, starting
throttle and idle positions.
Adjust the throttle cable only after
the unit is fully assembled – the
control handle must be in the normal
operating position.
Put the machine on the ground in
the normal operating position.
The throttle cable must lie parallel to
the flexible shaft and not be
wrapped around it since correct
adjustment of the throttle cable is
otherwise impossible.
English
15