Adjusting The Throttle Cable; Mounting The Kombitool - Stihl FR 131 T Instruction Manual

English
Fitting the Throttle Cable
A
2
A
1
Push the throttle cable (1) into the
N
two cable retainers (2)
about 20 cm/8 in (A) from either
end of the shaft.
WARNING
The whole length of the throttle cable
must run parallel to the flexible shaft. Do
not wrap the throttle cable around the
flexible shaft.
Go to "Adjusting the Throttle Cable".
N
16

Adjusting the Throttle Cable

It may be necessary to correct the
adjustment of the throttle cable after
1
assembling the machine or after a
prolonged period of operation.
Adjust the throttle cable only when the
unit is completely and properly
assembled.
2
Set the throttle trigger to the full
N
throttle position.
Carefully rotate the screw in the
N
throttle trigger in the direction of the
arrow until you feel initial resistance.
Then rotate it another half turn in the
same direction.

Mounting the KombiTool

STIHL brushcutter models with the letter
T in their designations have a split drive
shaft for mounting STIHL KombiTools.
Mounting the KombiTool
2
1
Push the lug (1) on the drive tube
N
into the slot (2) in the coupling
sleeve as far as stop.
3
4
When correctly installed, the red line (3)
(arrow point) must be flush with the end
of the coupling sleeve.
Tighten down the star knob (4)
N
firmly.
Removing the KombiTool
Reverse the above sequence to
N
remove the drive tube.
FR 131 T