English
5.5
Adjusting the throttle cable
► Check adjustment of throttle cable – see chap‐
ter on "Adjusting the Throttle Cable".
6
Adjusting the Throttle
Cable
A properly adjusted throttle cable is the precondi‐
tion for correct operation in the full throttle, start‐
ing throttle and idle positions.
Adjust the throttle cable only after the unit is fully
assembled – the control handle must be in the
normal operating position.
► Use a suitable tool to push the slide to the end
of the slot (see illustration).
2
► Press down the throttle trigger lockout (1) and
squeeze the throttle trigger (2) (full throttle) –
this sets the throttle cable correctly.
7
Fitting Padding
12
► Place the padding (1) against the underside of
► Close the padding with the press studs (2).
► Rotate the padding until the press studs are
8
8.1
1
The limit stop (1) must be mounted on the gear‐
head when you use a circular saw blade.
► Position the limit stop (1) on the gearhead
► Fit the three M6 x 14 mm screws (2) provided
6 Adjusting the Throttle Cable
the drive tube and fold it up and around the
drive tube.
under the drive tube.
Mounting the Deflector
Mounting the Limit Stop
WARNING
flange.
and tighten them down firmly.
2
2
1
0458-262-0121-C