CAMDEN CM-336 Installation Instructions

D o o r Ac t iv a ti o n D e v i c e s
CM-336
Battery Operated Active Infra-Red "Hands-Free" Switche
INSTALLATION INSTRUCTIONS
1. GENERAL DESCRIPTION
Sure-Wave™ Hands-Free switches are active infra-red devices
utilizing micro burst sensor technology, designed for use in
ADA compliant automatic door control applications. These
switches eliminate the spread of germs by avoiding physical
contact and offer building occupants greater convenience
when moving through the premises. Sure-Wave™ switches
are available with either stainless steel or impact resistant
polycarbonate faceplates, in narrow (jamb), single gang or
double gang configurations. All models are ROHS compliant
with lead-free construction.
2. APPLICATION
Sure-Wave™ battery powered hands-free switches are
American Disability Act (ADA) compliant, and provide
barrier free access and egress to buildings and washroom
facilities. Their rugged construction makes them ideal for
use on low-energy automatic doors, drive-up windows, and
interior and exterior doors in virtually any commercial (office,
retail), institutional (school, hospital or clinic), or industrial
(manufacturing) facility.
Three standard face plate widths are available:
CM-336: 2 ¾" x 4 ½" polycarbonate or stainless steel, fits on
single gang electrical boxes.
CM-336/N: 1 ¾" x 4 ½" polycarbonate or stainless steel.
CM-336/W: 4 ½" x 4 ½" polycarbonate or stainless steel, fits on
single gang, double gang or 4 x 4 electrical boxes.
All faceplates may be ordered up with a plain face, with the
waving hand symbol (/40), with the waving hand symbol and
words: WAVE TO OPEN (/41) or with the waving hand, and
wheelchair icons plus words: WAVE TO OPEN (/42).
3. INSTALLATION
Mounting
Sure-Wave™ may be mounted in door jambs, single or double
gang electrical boxes, and 4 x 4 boxes.
NOTE: The sealing gasket (included) is recommended for
outdoor or wet locations. If using with Automatic doors install
in accordance with ANSI A156.10 / A156.19. Select from one of
the following three mounting subsections:
SINGLE GANG ELECTRICAL BOX: CM-336
1a - If using an in-wall box ensure the box is plumb and
square, and flush with the wall surface. (See Diagram 1)
1b - If using a surface box, ensure it is secure & plumb.
2 - Using the dip switch located on the end of the unit, set the
operating mode. (See Section 4)
3 - Attach the unit to the enclosure using the two #6-32 screws
provided.
4 - Attach the faceplate to the unit using the two black
#6-32 x 3/8 machine screws or tamperproof screws.
Do not overtighten!!
s
Page 1 of 4