Control And Indicator Panel; Additional Controls And Indicators - Atlas Copco XAHS365 Md Instruction Manual

C
ONTROL AND INDICATOR PANEL
The control and indicator panel is located behind the small panel in
the front service door.
Push buttons and fuses
S1 ...... On/off push button
To switch the voltage on and to stop the engine.
S3 ...... Start push button
To start the engine.
S4 ...... Compressor loading push button
To load the compressor. Once the button is pressed, the
pressure starts building up.
S20 ....Emergency push button
To stop the compressor in case of emergency. This is done by
pushing the red button on the door of the control panel. To reset
the push button, press it and turn it anticlockwise. Use this
button only in case of an emergency.
Gauges
WPG ..Working pressure gauge
P1 ...... Fuel level gauge
P2 ...... Engine oil pressure gauge
P3 ...... Hourmeter
P4 ...... Temperature gauge, engine coolant
P6 ...... Tachometer
Cont & indic panel
Lamps
H1 ......Alternator charging indicator lamp
Goes out after starting, indicating that the alternator is
charging.
H2 ......Low fuel level alarm lamp
Starts flashing when there is only fuel left for approx. half an
hour of operation.
H3. .....Air filter servicing alarm lamp
Starts flashing if the air filter elements need servicing.
H7 ......Engine coolant temperature fault indicator lamp
Starts flashing if coolant temperature is too high.
H8 ......Engine oil pressure fault indicator lamp
Starts flashing if the engine oil pressure is too low.
H9 ......Compressor temperature fault indicator lamp
Starts flashing if the compressor element outlet temperature is
too high.
H10 ....Engine coolant level fault indicator lamp
Starts flashing if the coolant level is too low.
H11 ....Fuel level fault indicator lamp
Lights up if the fuel level is too low.
H13 ....Warming up indicator light
Indicates that the engine is warming up or cooling down
H14 ....Automatic load indicator light
Lights up when automatic load is chosen and the compressor is
waiting for loading.
H15 ....Manual load indicator light
Lights up when the compressor is loaded.
A
DDITIONAL CONTROLS AND INDICATORS
The compressor contains a number of controls and indicators which
are not situated on the control and indicator panel.
H22 ....Flasher light
Located above the front service door. Starts flashing when the
air filters need to be serviced, when there is only fuel left for
half an hour of operation or in case of a shutdown.
SG .....Sight glass oil level
The sight glass is located next to the air receiver and indicates
the oil level in the air receiver.
TG......Compressor element air outlet temperature gauge
Located behind the front service door and indicates the
temperature of the air at the outlet of the compressor element.
I M
NSTRUCTION ANUAL
11