Maserati QUATTROPORTE Owner's Manual page 37

of the "Auto Dim High Beams" soft-
key (see chapter "Functions of Settings
Menu on MIA" in section "Dashboard
Instruments and Controls").
The "Glare Free" function will be
engaged after the following actions:
• Engine run.
• Function enabled by MIA.
• Low beam on.
• Interior light switch in position
"Auto".
• Multifunction lever in "High beam"
activated position.
The "Glare Free" function will work if:
• The vehicle speed is equal or greater
than 40 km/h (25 mph) in the
engagement phase of the function.
• Environmental brightness is not
sufficient for a safe and comfortable
drive.
• Traffic scenario out of urban context.
Once the system will be active,
there will be two indicators on the
instrument cluster, showed in the same
time: one blue and one green.
The green indicator indicates that the
"Auto Dim High Beams" function is
activated on MIA; the blue indicator
indicates that all or only some high
beam LEDs are physically on in that
moment.
When instead there is the needing
to switch off the whole high beam
module to obtain the no glaring
effect, on the instrument cluster there
will be just one indicator on: the green
one.
When the scenario allows the partial
or full use of high beam with no
glaring disturbance, the blue indicator
will appear again.
NOTE:
• Some unpredictable conditions,
such as dirt, dust, film or any
other obstruction on camera lens
zone events could affect "Glare
Free" function making it working
improperly.
• Heavy rainy and foggy weather could
affect system performance, leaving
the full beam switched on for longer
time than the nominal working
Understanding the Vehicle
condition. This could cause a glaring
disturbance for other vehicles, to
avoid this the driver has to switch off
the high beam manually.
• In phase of disengagement of the
function, the minimum operating
speed is 30 km/h (18 mph).
• "Glare Free" function proper
operation is guaranteed if vehicle
speed is less than, or at least equal to
250 km/h (155 mph).
Automatic High Beam/Glare Free High
Beams Failure
In the event of a failure on high beam
system (Automatic or Glare Free
equipped, as well), the related amber
warning light will light up on the TFT
display.
Take your vehicle to the nearest
Center of the Service Network as soon
as possible avoiding to use this system.
2
35