Maserati QUATTROPORTE Owner's Manual page 223

Press and release ON/OFF button
to activate the ACC and enter the
"Driver Assist" page. The display will
show in the top left corner the
white symbol with below 3 dashes will
illuminate indicating that system is
ready to be set.
In the main area the symbology of
the other ADAS system set will be
displayed.
When exiting the "Drive Assist" page,
only the ADAS symbology will remain
on the top left corner.
If a vehicle is detected as being too
close, the display will show a message
for 5 seconds and trigger a buzzer to
warn the driver that current conditions
do not allow enabling of the ACC. At
any rate, system will remain in the
ready status.
Push the ON/OFF button a second time
and release to turn the system off.
A pop-up message is displayed for
2 seconds to indicate that ACC was
disabled.
Driver Assistance Systems
WARNING!
Leaving the Adaptive Cruise Control
(ACC) system on when not in use is
dangerous. You could accidentally
activate the system or cause it to go
faster than you want. Always leave
the system off when you are not using
it.
Setting the Speed
When vehicle reaches required
speed, press down and release
the multifunction control (SET -).
The display will show set speed
corresponding to vehicle current one.
Speed value will be indicated below
the green symbol and above the
distance bars, in the center of the
display.
Remove foot from accelerator pedal
and vehicle will continue at set speed.
6
221