Table of Contents
Advertisement
Device Management
3.2 Configuring the Device
The serial console port implements RS232 DCE (Data Communication Equipment) on
a DB9 connector. The following is the pin-out for the port:
Figure 3.1
a
Connected internally.
b
Connected internally.
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management
switch and access the RUGGEDCOM RS930W console and Web interfaces via the
device's IP address. The factory default IP address for the RUGGEDCOM RS930W is
https://192.168.0.1.
For more information about available ports, refer to
21)".
3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured.
All configuration management is done via the RUGGEDCOM RS930W interface. For
more information about configuring the device, refer to the "RUGGEDCOM ROS
Configuration Manual" associated with the installed software release.
20
1
5
9
6
Serial DB9 Console Port
Pin
Name
a
1
Reserved (Do Not Connect)
2
TX
3
RX
a
4
Reserved (Do Not Connect)
5
GND
a
6
Reserved (Do Not Connect)
b
7
Reserved (Do Not Connect)
b
8
Reserved (Do Not Connect)
9
Reserved (Do Not Connect)
"Communication Ports (Page
Installation Manual, 04/2022, C79000-G8976-1035-11
Description
Transmit Data
Receive Data
Signal Ground
RUGGEDCOM RS930W
Advertisement
Table of Contents
