JUMO 705043 Installation Instructions Manual page 42

2 Mounting
4. Fasten the end bracket (B) using a screwdriver (B4). For this purpose, ensure that the end bracket
is positioned flush against the router module.
NOTE!
The use of the end bracket (left of the router module) can be omitted if the router module is used together
with a central processing unit 705003. To do this, the router module must be pushed to the left against
the central processing unit after it has been placed on the DIN rail.
Dismounting a router module 1-port (705043)
Process:
1. Remove the connecting cable if required (Bus In).
The router module and all modules on the right next to the router module are isolated from the sys-
tem bus.
2. If required, use a screwdriver to release the wired terminal (D) of the router module (A) and pull off
toward the front (D1).
The connection to the voltage supply is isolated.
14
(B) (A)
(B2)
(A3)
(D1)
(A)
(C5)
(C)
(D)
(A6)
(A4)