BMW S 1000 RR Rider's Manual page 51

Motion sensor
Switching on ignition with an
unauthorized ignition key.
Disconnecting the DWA from
the motorcycle battery (DWA
battery takes over the power
supply – alarm sound only, haz-
ard warning lights do not flash).
If the DWA battery is discharged,
all functions remain operational;
the only difference is that the
alarm cannot be set off if the
system is disconnected from the
motorcycle battery.
The duration of the alarm is ap-
prox. 26 seconds. During the
alarm, an alarm tone sounds and
the turn indicators flash. The
type of alarm sound can be set
by an authorized BMW Motorrad
retailer.
If an alarm was triggered while
the motorcycle was unattended,
the rider is notified accordingly
by an alarm tone sounding once
when the ignition is switched
on. The DWA LED then signals
the reason for the alarm for one
minute.
Light signals on DWA LED:
1 flash: Motion sensor 1
2 flashes: Motion sensor 2
3 flashes: Ignition switched on
with unauthorized motorcycle
key
4 flashes: DWA disconnected
from motorcycle battery
5 flashes: Motion sensor 3
Deactivation
Set emergency on/off switch
(kill switch) to normal operating
position.
Switch on the ignition.
Turn indicators light up once.
Confirmation tone sounds once
(if programmed).
DWA is now switched off.
DWA Adjusting
Switching on ignition (
Briefly press SET 2 repeat-
SETUP MENU EN-
edly until
TER
3 is displayed.
NOTICE
If the display has been scrolled
too far, briefly press SET repeat-
edly until the menu returns to
4
49
40).
z