Bush DVD-225BHS Instruction Manual page 26

Using your DVD PLAYER
Let's get started
Sharpness: Use to set the sharpness of the DVD's image.
Press the ▼ button to select sharpness on the sub menu. Use the button access the slider.
To increase the sharpness press the ▲ button, or the ▼ button to decrease the sharpness.
When you have finished adjusting the setting press the button to go back to the sub menu.
Sound output
Select the Audio menu using the
Downmix: Use this to select the coding used on the DVD you wish to play the sound in.
LT/RT: Left/Right channel output.
Stereo: Standard stereo output.
Dolby Setup
Select the Dolby menu using the
Dynamic: This function is generally used when playing high volume programs at night and
you don't want to disturb any neighbours.
The setting can lower the volume but still keep the original quality of the sound.
button to open the sub menu. Change the setting using the ▲▼ buttons
Press the 
choose between OFF, 2/8, 4/8, 6/8 or FULL.
Dual Mono: Output mode of the L/R signals. Mix-mono can be only used if the DVD uses
5.1ch audio (check the case of the DVD).
If you are using an amplifier that has Dolby digital output mode, you may choose STEREO,
MONO L, MONO R, and MIX-MONO for the decoding the audio.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting
26
buttons on the remote control.

DOWNMIX
buttons on the remote control.

DYNAMIC RANGE
DUAL MONO

