Setup Menu Setting - Bush DVD-225BHS Instruction Manual

Using your DVD PLAYER
Let's get started

SETUP Menu Setting

Adjusting the system settings
1. Turn the DVD player on by pressing the
player.
2. Switch on your TV/Monitor and check it is set to the correct input source matching the
DVD Player connection: HDMI, SCART or RCA phono / CVBS (composite video). When the
correct source is selected the home screen will be displayed.
3. Press the SETUP button on the remote control to open the DVD's menu. The menu will
now be shown on the TV .
4. Use the direction buttons on the remote control to select the different menus.

Then use the ▲▼ buttons to select the sub menus you want to change.
Access the sub menu using the
to change to.
Repeatedly press the
Press the SETUP button to close the menus.
Note: Changes made to the DVD setup menu will be saved on switching player to standby
and/or switching off.
General
Use this sub-menu to set up the general settings for the DVD player.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting
22
TV SYSTEM
SCREEN SAVER
VIDEO
RESOLUTION
TV TYPE
PASSWORD
RATING
DEFAULT
button, then the ▲▼ buttons to select setting you want

button to go back to through the menus.

TV SYSTEM
SCREEN SAVER
VIDEO
RESOLUTION
TV TYPE
PASSWORD
RATING
DEFAULT
button on either the remote control or DVD
OFF
TV-RGB