Table of Contents
Advertisement
ACCESSORIES
CONNECTING THE MAGNUM 250 LX PUSH-
PULL GUN (K2704-1) AND MAGNUM 250LX
PUSH-PULL GUN ADAPTER (K2705-1)
See Figure C.2
1. Plug the 115 VAC cable into available 115V AC
receptacle. The POWER MIG® 255XT (K2701-1)
furnishes the 15A 115V AC auxiliary supply. The
receptacle is located at the back of the machine.
2. Connect the 4-pin connector cable of the Push-
Pull Gun Adapter to the 4-pin trigger receptacle
located in the front section of the wire drive com-
partment.
3. Connect the 7-pin connector cable of the Push-
Pull Gun to the 7-pin receptacle cable from the
adapter.
4. Connect the Push-Pull gas & power pin into the
POWER MIG® 255XT wire feeder brass bushing.
5. Attach a gas hose from the Gas supply to the
rear inlet gas fitting on the POWER MIG® 255XT.
MAGNUM
ADAPTER
250LX
4-PIN CABLE CONNECTORS
MAGNUM 250LX PUSH-PULL GUN
7-PIN
CABLE
CONNECTORS
ADAPTEUR
PLUG INTO
AVAILABLE 120 VAC
POWER SOURCE
FIGURE C.2
FIGURA C.2
C-8
Advertisement
Table of Contents
