Storage - Toro STX-38 Operator's Manual

Storage

1. Lower the grinder.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove dirt and grime from the external parts of the
entire machine, especially the engine. Clean dirt and
chaff from the outside of the engine cylinder head fins
and blower housing.
Important: You can wash the machine with mild
detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially
near the control panel, engine, hydraulic pumps,
and motors.
4. Service the air cleaner; refer to
Servicing the Air Cleaner (page 23).
5. Grease the machine; refer to
Greasing the Machine (page 22).
6. Change the engine oil; refer to
Changing the Engine Oil (page 24).
7. For storage over 30 days, prepare the machine as
follows:
A. Add a petroleum based stabilizer/conditioner to
fuel in the tank. Follow mixing instructions from
stabilizer manufacturer. (1 oz. per US gallon). Do
not use an alcohol based stabilizer (ethanol
or methanol).
Note: Fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline and used
at all times.
B. Run the engine to distribute conditioned fuel
through the fuel system (5 minutes).
C. Stop the engine, allow it to cool and drain the fuel
tank using a pump type syphon.
D. Restart the engine and run it until it stops.
E. Choke the engine.
F. Start and run the engine until it will not start again.
G. Dispose of fuel properly. Recycle as per local
codes.
Important: Do not store stabilizer/conditioned
gasoline over 90 days.
8. Remove the spark plugs and pour two tablespoons of
engine oil into each spark plug hole.
9. Place a rag over the spark plug holes to catch any oil
spray, then use the starter to crank the engine and
distribute the oil inside the cylinder.
10. Install the spark plugs, but do not install the wires on
them.
11. Charge the battery; refer to
Servicing the Battery (page 28).
12. Check and adjust the track tension; refer to
Checking and Adjusting the Track Tension (page 30).
13. Check and tighten all bolts, nuts, and screws. Repair or
replace any part that is damaged.
14. Paint all scratched or bare metal surfaces. Paint is
available from your Authorized Service Dealer.
15. Store the machine in a clean, dry garage or storage area.
Remove the key from the ignition switch and keep it in
a memorable place.
16. Cover the machine to protect it and keep it clean.
39