Table of Contents
Advertisement
Installation
10
All manuals and user guides at all-guides.com
Before starting, review the precautions on page 6.
To install the VideoMate 5000, proceed as follows:
1. Unwind the power cord under the base of the unit and
plug it into a suitable power source.
2. Connect the cable to your peripheral equipment
(TV monitor, video projector, etc.). The connection
for composite video is BNC and is a 4-PIN MiniDin
for Y/C (S-video). RGB/Sync can be accessed by
4 BNC connectors located under the handle.
The VideoMate 5000 outputs true red, green and blue
information as well as one standard video output. At
the factory, the unit was set up for RGB/Sync and Y/C
outputs. To use composite video (or vise versa), you
need to access the Menu button and switch off the
Y/C output.
Press MENU. This brings the menu to the TV
screen.
Press FUNCTION and move to Page 1.
Press DATA (while on Page 1). This will change
to Page 2.
Press FUNCTION and move to D-Sub Y/C.
Press DATA. This will change D-Sub VBS.
Press MENU to clear the menu from the TV
screen.
3. Load the slide tray and "power-up" all equipment
4. Switch the power switch to HIGH.
5. Adjust the iris (I) and TV monitor controls to produce
satisfactory image. Select a darker slide to adjust the
iris if necessary. The goal is to reach a compromise
position.
6. Adjust the focus (F) to produce a clear image.
Installation
Advertisement
Table of Contents
