Table of Contents
Advertisement
Removing the Slide Tray
Slide Tray Jam
All manuals and user guides at all-guides.com
To remove the tray from the projector without loosening
the slides:
1. Hold the selector bar down and rotate the tray back to
the zero index position.
2. Lift the tray at the point opposite the index mark.
The tray may jam if a damaged slide is caught in the gate.
To release the tray:
1. Turn the unit off.
2. Push the select bar down and the slide should come
up.
If the tray is still jammed:
1. While holding the projector post release tab located at
the center of the slide tray, grasp the tray on the side
opposite the index mark and lift. When the tray is
removed, the select bar will release the slide.
2. Invert the slide tray and rotate the bottom metal plate
until it locks into the zero position. This will prevent
the slides from falling out from the bottom of the slide
tray.
3. Return the tray to an upright position and remove the
lock ring. If the slide is undamaged, return it to its
proper slot. Replace the lock ring and continue.
Slide Tray
13
Advertisement
Table of Contents
