Table of Contents
Advertisement
Safety Precautions
8
All manuals and user guides at all-guides.com
To prevent damage to the equipment and operating
personnel, please observe the following precautions:
Use the correct voltage source as specified on the label.
Make sure that the voltage source contains a satisfactory
path to ground.
Do not operate the unit where liquids can come into
contact with the electrical components.
Maintain a six inch air space around all sides of the
equipment to allow for proper ventilation.
When changing the bulb:
1. Disconnect the electrical supply.
2. Allow the unit to cool.
3. Use only ESJ or ESH lamps or the equivalent (82 volt,
85 watt). Higher wattage lamps will cause severe
internal damage to the camera and electronics.
There are no user serviceable components (other than
changing the lamp). Opening the unit will expose danger-
ous voltage levels and sensitive electronic components.
A qualified technician should perform all repairs.
To protect the unit from damaging condensation and
thermal shock, certain procedures must be followed:
1. In cold weather, always put the unit in a moisture proof
container or enclosure before transporting.
2. Either keep the unit warm during transportation, or
allow sufficient time for it to warm up at the destina-
tion. Keep the unit in the original moisture proof
package while it warms up. (The goal is to prevent
warm, moist air from striking the cold electronic and
optical components which will cause damaging
condensation).
Warning! Never operate a cold projector to warm it up.
Safety Precautions
Advertisement
Table of Contents
