Fitting/replacing bulbs (Max. 3.5W LED GU10)
When changing a bulb, always switch off at the mains and allow the bulb to cool before handling. Dispose of
used bulbs carefully. Use a soft cloth to handle bulbs, avoid directly touching the bulbs as this will shorten their life. Do not
exceed the wattage stated or use a different shape bulb from that indicated on the fitting.
Check with your retailer re bulb dimming capability before purchasing replacement bulbs.
Bulb type - 7W LED GU10
1. Unscrew the bezel
2. Remove the old bulb by turning anti-clockwise.
3. Insert new bulb.
4. Replace the bezel ensuring that it is tightly secured.
Care and Cleaning
Do not use solvents or abrasive cleaners as these could
damage the finish.
In normal circumstances, stainless steel is very resistant to
corrosion. It does however require maintenance to preserve
the high quality appearance. Wash the product with warm
soapy water, removing all surface deposits. Rinse with clear
water and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation.
This is normally caused by tiny iron particles left behind
after the brushing process when finishing.
Wash and dry as detailed above. Then with a soft cloth
soaked with a protective oil, wipe all over.
Recycling advice
Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist.
Check with your Local Authority or retailer for recycling advice.
Safety information
For your safety, always switch off the supply before cleaning.
The shade must be replaced immediately should the shade become cracked or damaged. This fitting
must not be used without the shade in place.
www.saxbylighting.com
3.5W LED
GU10
However if the product is subject to extreme environmental
conditions such as marine locations, industrial pollution
and acid rain these maintenance procedures should be
carried out around four times a year. For severe corrosion,
non-abrasive cream cleaners or proprietary stainless steel
cleaners should be used to remove the corrosion. Wash and
dry as detailed above. Then with a soft cloth soaked with a
protective oil, wipe all over.
Iss.4 080820182018
Saxby Lighting. BH23 3PE
Instruction leaflet
Odyssey Spike
ST5011
Need help?
Do you have a question about the Odyssey Spike and is the answer not in the manual?
Questions and answers