Assembly - RADLEY 5131-001 Owner's Manual

ASSEMBLY

FITTING THE TRANSPORTATION WHEELS
WARNING! You may need assistance to lift the machine out of the box and
assemble it.
NOTE: Before using the chipper/shredder, read the instruction book
carefully.
Before using the chipper/shredder, some assembly is required.
1. Turn the machine upside down on a flat surface and rotate the two brackets
from the outside of the machine to the upright position (Fig. 1).
2. Attach the axle tube between the left and right brackets. Slide the axle
through the assembly hole in left bracket then through out the other assem-
bly hole in the right bracket.
3. Position the washers and wheel bushings on each end of the axle tube. Then
assemble the wheels onto each end of the axle end. Use the selflocking nuts
on each end of the axle and tighten both the self-locking nuts using the
wrench supplied (Fig. 2).
4. Attach the wheel cover and make sure everything is assembled in the correct
position.
NOTE: The wheels must be fitted the correct way round to allow the nuts
to tighten on each end of the axle.
Fig. 1
SAVE THESE INSTRUCTIONS FOR REFERENCE
wheel cover wheel
nut
washer
wheel
bushing
Fig. 2
5131-001
axle
left
tube
bracket
assembly holes
8