RADLEY 5131-001 Owner's Manual page 12

START/STOP THE SHREDDER
1. Connect to the electric power supply.
2. To switch on the shredder, press the power On/Off switch to the ON
position (Fig. 5).
3. To switch off, simply press the On/Off switch to the OFF position (Fig. 6).
NOTE: Ensure power On/Off switch is in the OFF position before plugging
in the shredder.
WARNING! Do not put your hands into the feeding chute.
The shredder must be used in the upright position only. Do not operate the
shredder if it is lying on its side.
When feeding long woody branches/stems into the shredder, be careful of
whip and vibrations as they get caught by the cutter.
The cutting device has a tendency to pull branches/stems into the machine. Do
not try to impede entry of the material being cut once feeding has started.
CLEARING OBSTRUCTIONS
If the shredder becomes jammed, power to the motor will automatically cut off.
If the shredder jams and can not be restarted, the following actions should be
taken.
1. Switch the shredder OFF.
2. Disconnect shredder from electric power supply before attempting to
unblock any jams.
3. Unscrew locking knob, located on underside of cover.
4. Lift body cover up so you can clearly see the cutting section.
5. Remove any twigs, branches or other material that may be clogging the
blades, feeding chute or discharge chute.
6. Close body cover, make sure it is correctly located and securely retighten the
locking knob.
READ ALL INSTRUCTIONS BEFORE USING THIS CHIPPER/SHREDDER
11
15 Amp Chipper/Shredder - Owner's Manual