Sony PDW-F355L Operating Instructions Manual page 42

To attach a WRR-855
1
Open the cover of the WRR connector.
2
Set the power switch of the WRR-855 to ON, and set
MUTING to ON or OFF.
This enables the WRR-855 power to be turned on and
off with the camcorder POWER switch.
3
Insert the WRR-855 into the CA-WR855.
4
Engage the V-shaped plate on the back of the
CA-WR855 with the V-groove on the battery
attachment shoe, and then slide the CA-WR855 down
until it connects to the WRR connector.
5
Set the AUDIO IN switch to WIRELESS (for CH-1/
CH-2) or W (for CH-3/CH-4).
To attach a WRR-861/862 (When using a
BP-GL95/GL65/L60S/L80S Battery Pack)
1
Attach a WRR tuner fitting (not supplied, service part
number: A-8278-057-B) to the back of the camcorder.
42
Preparing the Audio Input System
WRR connector
Fasten the screws
(supplied with the WRR-855).
CA-WR855
1 Use a Phillips type screwdriver to tighten the four
screws placed in the tuner fitting as illustrated
below.
Note
Check that the four screws are firmly tightened.
2 Loosen the adjustment screws of the tuner fitting.
3 Adjust the tuner fitting position for a BP-GL95/
GL65/L60S/L80S Battery Pack to be attached, and
tighten the adjustment screws to fix its position.
4 Attach the mount plate supplied with the WRR-
861/862.
BP-GL95/GL65/L60S/L80S
Adjustment
screws
Back of the
camcorder
2
Attach the battery pack.
For details about attaching the battery pack, see
"Using a Battery Pack" on page 30.
3
Mount the tuner on the WRR tuner fitting.
For details about the WRR tuner fitting (service part
number: A-8278-057-B), contact your Sony dealer.
4
Connect the tuner power cord to the DC OUT
connector of the camcorder, and the audio output cable
to the AUDIO IN CH-1 or CH-2 connector.
5
Set the switches as follows.
Mount plate (supplied
with WRR-861/862)
Phillips type screwdriver
WRR-861/862