Checking The Installation; Using A Security World - Entrust nShield Connect Installation Manual

Enabling the push feature allows any client computer to change the
HSM configuration file and gives the client the power to make

configuration changes that are normally only available through the
HSM secure user interface.
Once you have setup the nShield Connect for zero touch configuration, everything that
can be configured using the front panel, can then be configured remotely using one of
the following methods:
• The nShield Connect Serial Console
• The cfg-pushnethsm
Connect (see the nShield Connect User Guide). From the configuration file you can
configure the RFS, add clients, or change the network configuration.
• The nethsmadmin

9.7. Checking the installation

To check that the module is installed and configured correctly on the client:
1. Log in as a user and open a command window.
2. Run the command:
enquiry
For an example of the output following a successful
utility.
If you are configuring a client belonging to an nShield Connect, the response to the
enquiry
command should be populated and the
mode operational
If the is
mode is initialization, the HSM has been installed correctly, but you must
If the
change the mode to operational.
If the output from the
restart your computer, then re-run the

9.8. Using a Security World

See the User Guide for more about creating a Security World or loading an existing one.
nShield® Connect Installation Guide
utility to push an updated configuration file to the nShield
utility (see the nShield Connect User Guide).
the HSM has been installed correctly.
enquiry
command says that the module is not found, first
enquiry
hardware status
enquiry
command.
command. See Enquiry
shown as OK.
54 of 73