Entrust nShield Connect Installation Manual page 33

9.2.2.3. Enable/disable IPv6
To enable/disable IPv6:
1. From the front panel menu, select System > System configuration > Network config
> Set up interface #1 > Configure #1 IPv6 > Enable/Disable IPv6.
The following screen displays:
Network configuration
IPv6 enable/disable:
DISABLE
CANCEL FINISH
2. Set the ENABLE/DISABLE field to the required option.
3. To accept, press the right-hand navigation button.
9.2.2.4. Set up IPv6 static address
To set up IPv6 static address:
1. From the front panel menu, select System > System configuration > Network config
> Set up interface #1 > Configure #1 IPv6 > Static addr/SLAAC > Select
Static/SLAAC.
The following screen is displayed:
Network configuration
Do you want to use a
static address or
SLAAC?
Select static and press the right-hand navigation button.
Then, select Static IPv6 address and press the right-hand navigation button.
The following screen displays:
Network configuration
Enter IPv6 address
For interface #1:
CANCEL NEXT
2. Enter the required IPv6 address.
3. When the IPv6 address is correct, press the right-hand navigation button. The
following screen displays:
nShield® Connect Installation Guide 33 of 73