Entrust nShield Connect Installation Manual page 40

Select the interface for the IPv6 gateway. Press the right-hand navigation button to
accept.
9.2.6. Set up Routing
9.2.6.1. Set up routing for IPv4
To set a new route entry for IPv4:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > New IPv4 route entry.
The following screen is displayed:
Edit route entry
Enter IP range
and mask length:
0. 0. 0. 0/ 0
Enter the gateway:
0. 0. 0. 0
CANCEL FINISH
2. Enter the IPv4 address range details for the route. Press the right-hand navigation
button to accept.
9.2.6.2. Set up routing for IPv6
To set a new route entry for IPv6:
1. From the front panel menu, select System > System configuration > Network config
> Set up routing > New IPv6 route entry.
The following screen is displayed:
Edit route entry
Enter the IP range
and prefix length:
::/64
CANCEL NEXT
2. Enter the IPv6 address range details for the route. Press the right-hand navigation
button to accept. The following screen is displayed:
nShield® Connect Installation Guide 40 of 73