Sony DXC-D50K, DXC-D50PK, DXC-D50L, DXC-D50L, DXC-D50WSL, DXC-D50WSPL, DXC-D50H, DXC-D50PH, DXC-D50WSH Operating Instructions Manual page 66

Menu Operation
Submenu title Page
<KNEE/WHITE CLIP> P5
<WHITE SHADING> P6
<SKIN DTL/MATRIX> P7
66
Chapter 4 Viewfinder Screen Indications and Menus
Setting item: Selectable
Initial value values
KNEE POINT: 0 –99 to 0 to 99
(not available when DCC
is activated)
KNEE SLOPE: 0 –99 to 0 to 99
(not available when DCC
is activated)
WHITE CLIP: 0 –99 to 0 to 99
V MODULATION: –99 to 0 to 99
[R] 0 [G] 0 [B] 0
SKIN DTL: OFF ON, OFF
LEVEL: 50 0 to 50 to 99
SET: EXECUTE
PHASE: 0 0 to 359 to 0
WIDTH: 30 0 to 30 to 90
SATURATION: –89 –99 to 0 to 99
GATE: OFF ON, OFF
SKIN MATRIX
SATURATION: 0 –99 to 0 to 99
HUE: 0 –99 to 0 to 99
Remarks
To adjust the knee point
To adjust the knee slope
To adjust the white clip level
For vertical shading correction of the white
To turn skin tone detail on/off
To adjust the detail level when skin-tone detail
is set to ON. At 99, the maximum effects are
obtained.
— To execute the skin set (The box cursor
appears at the center of the screen. Move the
cursor to where you wish to execute the skin set
by turning the MENU dial, then press it to
execute the skin set. For about 3 seconds after
the MENU dial is pressed, a zebra pattern will
be displayed to indicate the location where the
skin tone is activated.)
To adjust the color phase when the skin-tone
detail is activated (the color phase is
automatically calculated when SET is executed,
but it can be manually changed)
To adjust the width of color phase when skin-
tone detail is activated (as the value becomes
smaller, the width of the detail effects
decreases)
To adjust the saturation (color intensity) of the
color on which skin-tone detail is to function
To turn on/off the function that enables checking
of the range where skin-tone detail is
functioning (If GATE is set to ON, the areas
where skin-tone detail is functioning can be
checked with the zebra signal displayed on the
viewfinder. If the MONITOR OUT signal is
monitored, the color tone of the area where
skin-tone deail is functioning changes. The
GATE signal is not superimposed on the output
from the VIDEO OUT connector.)
— To change the matrix of the phase area where
skin-tone detail is functioning
To adjust the color saturation (color intensity)
To adjust the hue