Summary of Contents for Jackson Systems Limit STAT
Page 1
Limit Installation Manual STAT Application Limit Stat™ is designed to prevent the user from adjusting the temperature beyond a specific heating limit, thereby greatly reducing utility bills. This installation manual covers the LSL-HOB single stage, heat only, battery powered Limit Stat™.
Page 2
When using the LSL-HOB battery powered is limited, affected by direct sunlight or other Limit Stat™, the batteries must be removed areas not typical of the temperature in the before changing any jumper settings. Wait at space.
Page 3
This thermostat must be wired in accordance Temperature Change Buttons with all applicable local codes and ordinances. When the Limit Stat™ is in the HEAT mode, a The thermostat should be limited to a maximum of 1.5 amps. Higher current may single press on either the UP or DOWN button cause damage to the thermostat.
Page 4
Setting the Heating Limit This manual is to be used by the installer only and contains information on setting the heating setpoint limit. Avoid leaving this installation manual with anyone who could compromise the settings. To set the Heating setpoint limit, place the MODE switch in the OFF position.