Advertisement
Setting the Heating Limit
This manual is to be used by the installer only and contains
information on setting the heating setpoint limit. Avoid leaving this
installation manual with anyone who could compromise the settings.
To set the Heating setpoint limit, place the MODE switch in the OFF
position. Press and hold the UP button while sliding the MODE switch to
Heat. The LCD will display "Ht LIM". Adjust the maximum heating setpoint
by using the UP and DOWN buttons.
NOTE: If no buttons are pressed for 4 seconds, the thermostat will accept
the limit value that is displayed on the LCD and return to normal operation.
Once the heating setpoint limit is adjusted and the thermostat returns to
normal operation, confirm that the setpoint can not be raised above the
limit and then allow the thermostat to return to normal operation.
5418 Elmwood Avenue, Indianapolis, IN 46203-6025
Toll Free: 888.652.9663 Fax: 317.227.1034
www.jacksonsystems.com
06-1071-062011
Advertisement
