Soleus Air SOLEUSAIR SG-TTW-09ESE-26 Operating Instructions Manual page 7

To replace front grille:
Hook the tabs on the front grille even with the tabs on the
case and snap into place. Replace the screws and filter.
Refer to Page 4, Figure A.
VENT CONTROL AND AIR DIRECTION (See Figure E)
The vent control is located behind the front grille on the right
side of the air discharge area. When set at CLOSE only the
air inside the room will be circulated and conditioned. When
set at OPEN, some inside air is exhausted outside.
Locating
Hole
Screw Hole
OPEN position
(Mesh end toward back)
Figure E
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove the vent card, turn it over and replace it by
locating rear hole in card over locating pin inside air
discharge and reattaching screw at front.
Grille
Tab
Locating
Hole
Screw Hole
CLOSE position
(Mesh end toward front)
EXHAUST AIR VENT
AIR DIRECTION:
Horizontal louvers on the front grille let you control the air
direction up and down.
4
Figure 4