About Switch Between Fahrenheit And Centigrade; Changing Batteries And Notices - Soleus Air SOLEUSAIR SG-TTW-09ESE-26 Operating Instructions Manual

Air Conditioner
Features
Guide for operation- General operation
1. To power on the unit, press the ON/OFF button. The unit will start to run. (Note: When
it is powered off, the louvers will close automatically.)
2. Press MODE button, select desired running mode, or press COOL or HEAT
mode to enter into the corresponding operation directly.
3. Press the + or - button to set the desired temperature. (It is unnecessary
to set the temp. in AUTO mode.)
4. Press the FAN button to set fan speed. Select AUTO, FAN 1, FAN 2,
FAN 3 or FAN 4.
5. Press the SWING button to select the swing function.
Guide for operation- Optional operation
1. Press SLEEP button, to set sleep.
2. Press TIMER button, to set the scheduled timer on or timer off.
Introduction for special function
★
About AUTO RUN
When AUTO RUN mode is selected, the set temperature will not be displayed on the
LCD. The unit will display the room temperature and automatically select the
operating mode based on the current room temperature.
★ About LOCK
When the unit is on or off, hold "+" and "-" key simultaneously to lock and
unlock the keypad. When locked, the display will show the LOCK icon, in which case the
lock icon will flash three times when a key is pressed. After the keypad is unlocked, the
lock icon on the display will disappear. When the unit is on, the default is unlock.
★

About switch between Fahrenheit and Centigrade

When the unit is off, hold "-" and "MODE" keys simultaneously to switch between
℃ ℉.
and

Changing batteries and notices

1.
Slightly press the cover clip
remote control.(As shown in figure)
2.
Take out the old batteries. (As show in figure)
3.
Insert two new AAA batteries, and pay attention to the polarity.
(As shown in figure)
4.
Attach the back cover of the remote control. (As show in figure)
NOTE:
★
●
When changing the batteries, do not use old or different batteries,
otherwise, it can cause the remote control to malfunction.
● If the wireless remote control will not be used for a long time, please
remove the batteries to prevent leakage that could damage the
remote control.
●
The operation should be in its receiving range.
●
It should be placed at where is 1m away from the TV set or stereo sound sets.
If the remote control is not operating normally, remove the batteries
●
and reinsert after 30 seconds. Replace the batteries if the remote is not responsive.
to take out the back cover of
9