Through-The-Wall Installation Instructions - Soleus Air KC-45H Operating And Installation Manual

Thru-wall Installation Instructions
Kit RS100 for Soleus Air brand Compact Room Air Conditioner
Introduction
This instruction sheet provides guidelines for
installing a compact air conditioner through an
outside wall.
Installing an air conditioner through a wall requires
extensive carpentry and/or masonry experience.
Thru-wall installations performed by inexperienced or
unqualified individuals can result in costly damage to
home.
Air Conditioner Dimensions
The following figures show the outside dimensions of
air conditioner with chassis installed, and
dimensions of outer case with chassis removed.
Air Conditioner Dimensions
(with chassis installed)
Outer Case Dimensions
(chassis removed)
General Instructions
All Soleus Air brand Compact Room Air Conditioners
feature a slide-out chassis. Chassis and front cover
must be removed from outer case for installation.
In order to reinstall the chassis and reattach the air
conditioner front cover, the installed outer case must
be square and level from side to side. Use wood
shims between sides of case and finished opening–
especially where case is secured to opening–to
prevent warping or distorting. Check installed case for
distortion using carpenter's square.
A finished opening 26
high is recommended. The lower left inside corner of
opening must be within 5 feet of an appropriate
electrical outlet (see Use and Care manual for
electrical requirements.)
When wall thickness exceeds 9 -inches, opening
must be modified to allow air to enter side louvers on
case (see special instructions on back ). Do not
install air conditioner in walls thicker than 11
inches.
Dimensions of Finished Opening
Masonry Construction
See CAUTION under General Instructions. In
masonry walls, cut or build a finished opening 17-
inches high by 26
1/8
properly positioned in opening, secure it in place
with mortar or concrete nails driven through holes in
sides of outer case (shim case and predrill holes
before securing with nails).
15
- inches wide x 17-inches
1/8
-inches wide. When case is
-
2/5