Installation Instructions - Soleus Air TTWM1-10-01 Operating Instructions Manual

INSTALLATION INSTRUCTIONS

Once a compatible Solues Air sleeve (sold separately) is assembled, you may need to follow below
steps to properly install the unit into the sleeve.
NOTE: Sleeve assembly instruction is not included in this manual.
1. Attach(2) 4 1/2" x 3 1/2" x 1 1/2" Centering Support Blocks one on each side wall. Place in center of
side wall with the tapered end facing the opening (Fig. A).
2. Gently slide unit into sleeve.
3. Slide the unit completely to the rear to ensure a good seal, making sure the ground wire does not be-
come tangled.
4. Seal & Frame the unit as described in next page.
Centering Support Block
*Actual Sleeve may differ from image shown above.
*Grille is not included
Tapered
End
7
Centering Support Block
Fig. A