4. Connect the keyboard cable to the keyboard-controller board and close the latch to secure the cable.
5. Connect the keyboard-backlight cable to the keyboard-controller board and close the latch to secure the cable.
6. Adhere the Mylar on to the keyboard-controller board.
Next steps
1. Install the battery.
2. Install the
base
cover.
3. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
memory
module.
4. Remove the
M.2 2230 solid-state drive
5. Remove the
M.2 2230 solid state drive
6. Remove the
wireless
card.
7. Remove the
rear-I/O
8. Remove the battery.
About this task
The following image indicates the connectors on your system board.
1. Display cable
2. Alien head LED-cable
3. Power-adapter port cable
4. Right-fan cable
5. Speaker cable
6. M.2 card slot for solid-state drive 2
7. Battery cable
8. Touchpad connector
9. Keyboard-controller board cable
10. Tron-light cable
After working inside your
Before working inside your
or
M.2 2280 solid-state drive
or
M.2 2280 solid-state drive
cover.
computer.
computer.
in slot one, whichever applicable.
in slot two, whichever applicable.
51