Cleaning Water Inlet Strainers - Siemens Silver WD7205 Operating And Installation Instructions

Cleaning water inlet
strainers
Cleaning the strainer
at the water tap
Remove the pump cap.
Remove any loose debris/fluff from inside the pump
and clean the pump. The pump impeller must be
able to rotate. Clean any residual suds or fluff from
the thread of the pump cap and pump housing.
Attach and tighten the pump cap.
Attach and close the cover plate.
To avoid unused detergent from flowing into the
drain during the next wash cycle:
Pour 1 litre of water into chamber II
, ,
Select the Draining programme.
This necessary if very little or no water flows into
the washing machine.
First release the water pressure in the supply hose:
Turn of the water tap.
Turn the programme selector to any programme.
, ,
(Except Spinning and
, ,
Press the Start button, and allow the programme
to run for approx.40 seconds.
Disconnect the hose from the water tap.
Rinse the strainer under flowing water.
Reconnect the hose.
, ,
, ,
, ,
Draining )
, ,
, ,
33