Advertisement
Quick Links
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you
are happy with the product before removing protective film. Once the film is removed you cannot return
Be sure to read these instructions thoroughly before opening and installing the Can-Am Full Polycarbonate Windshield.
1.
Check over the parts included in the cartons with the parts list shown below:
2" Loom Clamps
1 1/2" Loom Clamps
1" Stainless Steels Bolts
Small SS Washers
Plastic Thumb Nuts
Large SS Washers
Large Rubber Washers
2" Adhesive Rubber Strips
56" Small Side Bulb Gasket
3" Velcro Tabs
3" Adhesive Hook Strips
Polycarbonate Windshield
If any parts are damaged or missing please contact customer service at (606) 845-7439.
2.
Start by pulling it out of the box and find a clean area to lay it down and install the hardware. Begin by peeling off the
protective film. Next take the 56" piece of rubber gasket and starting at one end firmly place across the bottom of the
windshield. You may need to trim off excess gasket. The diagram below show where to install the gasket.
3. Now the Windshield is ready to be installed. With the help of a friend, place the Windshield on the X3, setting it
up onto the hood.
2515 Bypass Rd. Flemingsburg, KY 41041
Instructions for Installation and Care of Can Am Maverick X3
Full Polycarbonate Windshield
CA-X3-WD02 / 50-40054
the product for a full refund.
606-845-7439
6 each
2 each
8 each
8 each
8 each
8 each
8 each
6 each
1 each
2 each
2 each
1 each
Advertisement
Related Manuals for FALCON RIDGE CA-X3-WD02
Summary of Contents for FALCON RIDGE CA-X3-WD02
- Page 1 Instructions for Installation and Care of Can Am Maverick X3 Full Polycarbonate Windshield CA-X3-WD02 / 50-40054 NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund.
- Page 2 4. Take the remaining hardware and install the windshield to the roll cage as shown in the diagram below. 5. If you have the intrusion bars installed on your X3 you will want to place the adhesive foam strips on the front edges of the bars where they will come in to contact with the windshield.
- Page 3 Warranty To The Owner of this Product: Thank you for purchasing one of our Falcon Ridge Cab Enclosures, Tops &/or Windshields! Below are the terms under which your product is covered under our manufacturer’s warranty. 30 Day Warranty which includes and is not limited to replacing the enclosure, tops and/or windshield due to defect of the product.