1. Manuals
  2. Brands
  3. Fusion3 Manuals
  4. 3D Printers
  5. EDGE
  6. Maintenance

Fusion3 EDGE Maintenance

Gaining access for maintenance & repair
Hide thumbs Also See for EDGE:
1
2
3
4
5

Advertisement

Table of Contents

EDGE 3D Printer
MAINTENANCE:
GAINING ACCESS FOR MAINTENANCE &
REPAIR
Revision 5/28/2022
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EDGE and is the answer not in the manual?

Questions and answers

Related Manuals for Fusion3 EDGE

Summary of Contents for Fusion3 EDGE

  • Page 1 EDGE 3D Printer MAINTENANCE: GAINING ACCESS FOR MAINTENANCE & REPAIR Revision 5/28/2022...
  • Page 2 It is NOT necessary to remove any additional panels or sheet metal parts from the machine to access EVERYTHING. All other sheet metal components are major structural components and removing them may render your machine permanently inoperable unless you return it to Fusion3 for a factory rebuild. MAIN DOOR Simply open or close the main door as normal.
  • Page 3 2. Grab the window with your other hand and remove it from the printer. To reinstall, simply drop back into place and make sure it sits flush with the outside face of the chassis. The magnets go out the outside (aka top) face of the window...
  • Page 4 Position EDGE so that you can access the outside rear face of the unit. 1. Remove the 9 M3x6 SHCS screws and set them aside. Remove the center-top screw last so you can get your hand under the bottom edge to support it as you remove the last screw.
  • Page 5 ELECTRONICS BAY SERVICE PANEL The electronics bay service panel gives access to the electronics of EDGE without removing the electronics sled from the machine. WARNING: High voltage components are present inside the electronics bay. You should unplug the unit from the wall and wait 5-10 min before opening the electronics bay for service.

Table of Contents